Hydraulic Tool Warranty, Sales & Service
HYDRAULIC TOOL LABOR RATES
All Replacement Parts to be Estimated
| HYDRAULIC TOOL | LABOR FEE |
|---|---|
| AIR OVER HYDRAULIC JACK | $140.00 |
| SINGLE CYLINDER | $75.00 |
| TRANSMISSION JACK | $175.00 |
We service many different power tools, and all have their own individual standards. All power tools are tested when they come in. We attempt to duplicate the complaint or malfunction. Each power tool is cleaned and inspected for wear or breakage. Required repairs are evaluated and quoted to the customer. Once the estimate has been approved, we reassemble with quoted parts and tested according to manufactures recommendations.
OUR POLICY: TOOL SERVICE AND REPAIR
LIMITED SLOTS AVAILABLE
Labor FEE: $95.00 (Parts not included)
- MANY PARTS IN STOCK
- MINIMUM LABOR $30.00 PAYABLE AT TIME OF CHECK IN. NON-REFUNDABLE AND APPLIED TO REPAIR AT TIME OF PICK UP
- ALL BRANDS PORTABLE ELECTRIC, AIR TOOL, HYDRAULIC, AND GAS
- ALL WARRANTY TOOLS ARE ACCEPTED UNDER MANUFACTURERS CONDITIONS
- NEW TOOLS, ACCESSORIES, BIT AND BLADE SHARPENING, RESEARCH, HARD TO FIND ITEMS, BATTERIES
For faster service download, print and complete the
Service and Repair PDF before dropping off your equipment.
TESTING
We thoroughly test and visually inspect your hydraulic tool before we begin repairs.
DISASSEMBLE & CLEAN
Once the testing is complete, we disassemble and clean your hydraulic tool.
INSPECT ALL PARTS FOR WEAR & BREAKAGE
While the tool is disassembled, we inspect all parts for wear and tear, and breakage.
ESTIMATE PARTS
At this point, we provide a complete parts estimate to you. We provide our recommendation on worn parts and also essential replacement needs.
REPLACE PARTS
We understand your tools are your business. Down time may hinder your work time. any parts not stocked will be a priority to procure.
ASSEMBLE
We use manufacturer assembly recommendations, specified torques, and lubrication.
TEST RUN AND TEST EQUIPMENT
Your hydraulic tool repair would not be complete without a test run. Only when running your tools can we detect the adjustments required to make it perform its best. We use tool-specific testing methods according to the manufacturer’s specifications. Some equipment examples:
- TORQUE TESTER – AGAINST MANUFACTURERS SPECIFICATIONS. (USED FOR IMPACT WRENCHES)
- HAMMERS – BLOWS PER SECOND
- SANDERS LOAD, NO LOAD SPEED – TEST
- INDICATOR – SPEED TEST (GUN TEST)
